BQWWP - FLAME GUARD 25A, F-15P32

Product Identification

Product ID:FLAME GUARD 25A, F-15P32
MSDS Date:11/19/1990
FSC:8010
NIIN:00N037836
MSDS Number: BQWWP

Responsible Party
SEAGRAVE COATINGS CORP OF VA
4030 SEAGUARD AVE
PORTSMOUTH, VA 23701
US

Emergency Phone: 804-488-4411

Info Phone: 804-488-4411

Cage: 60163

Contractor
SHERWIN-WILLIAMS, SEAGUARD
PORTSMOUTH, VA 23704 US

Telephone: 757-397-2223

Cage: 60163

Ingredients

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 20%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293


0.6 @ 20C.

CAS: 1309-64-4

RTECS: CC5650000

Fraction By Weight: 5%

OSHA PEL 0.5 MG/M3 (SB)

ACGIH TLV: 0.5 MG/M3 (SB)

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


PROPIONIC ACID, 2-METHYL-, MONOESTER W/2,2,4-TRIMETHYL-1,

CAS: 25265-77-4

RTECS: UF6000000

Fraction By Weight: 5%

ACGIH TLV: 10 PPM;15 STEL (MFR)

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:INHALATION:IRRITATION TO RESPIRATORY
TRACT, HEADACHE, DIZZINESS & NAUSEA. SKIN CONTACT:PRIMARY
IRRITATION. EYE CONTACT:PRIMARY IRRITATION.
Explanation of Carcinogenicity:ANTIMONY OXIDE IS LISTED AS A GROUP 2B
CARCINOGEN BY IARC MONOGRAPHS, VOLUME 47, P.291, 1989.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PRE-EXISTING SENSITIVITY TO
SOLVENTS CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS
PRODUCT.

First Aid

First Aid:INGEST:CALL MD IMMEDIATELY . INHAL:REMOVE TO FRESH AIR,
RESTORE BREATHING. CONSULT MD. SKIN:FLUSH W/WATER. EYE:FLUSH
IMMEDIATELY W/LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES.
CONSULT MD.

Fire Fighting

Flash Point Method:TCC
Flash Point:248F,120C
Lower Limits:0.6%
Upper Limits:4.2%
Extinguishing Media:WATER FOG, CARBON DIOXIDE, FOAM, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
. WATER MAY BE USED TO COOL CLSD CNTNRS TO PVNT PRESS BUILD-UP &
POSS AUTOIGNIT/EXPLO WHEN EXPOSED (SUPDAT)
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE
FROM HEAT, SPARKS & OPEN FLAME. CLOSED CONTAINERS MAY EXPLODE WHEN
EXPOSED TO EXTREME HEAT.

Accidental Release

Spill Release Procedures:AVOID BREATHING SOLVENT VAPOR. ENSURE ADEQUATE
VENTILATION. AVOID SPARKS, FLAMES & ANYTHING WHICH COULD CAUSE
FIRE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE IN A COOL DRY AREA W/VENTILATION
SUITABLE FOR STORING MATERIALS SHOWN IN INGREDIENTS SECTION.
Other Precautions:PROVIDE NIOSH/MSHA APPROVED RESPIRATORY PROTECTION
AGAINST FUMES GENERATED DURING BURNING.

Exposure Controls

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR TYPES SUITABLE
FOR MATERIALS IN INGS SECTION RECOM. NIOSH/MSHA APPROVED
CHEMICAL/MECHANICAL FILTERS RECOM WHEN VENT IS RESTRICTED.
NIOSH/MSHA APPROVED AIRLINE TYPE RESPI RATORS/HOODS RECOM IN
CONFINED AREAS.
Ventilation:SUFFICIENT VENT, IN VOL & PATTERN, SHOULD BE PROVIDED TO
KEEP AIR CONTAM BELOW CURRENT APPLIC OSHA PEL/ACGIH TLV LIMITS.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEM WORK GOGG/FULL LGTH FCSHLD .
Other Protective Equipment:USE PROTECTIVE CREAMS WHEN SKIN CONTACT IS
LIKELY. REMOVE & WASH CONTAMINATED CLOTHING BEFORE REUSE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING. SMOKE IN
DESIGNATED AREAS ONLY.
Supplemental Safety and Health
FIRE FIGHT PROC:TO EXTREME HEAT.

Chemical Properties

Boiling Pt:B.P. Text:471F,244C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:1.41
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:SOLUBLE
Appearance and Odor:OFF WHITE LIQUID; GLYCOL ETHER ODOR.
Percent Volatiles by Volume:93.1

Stability

Stability Indicator/Materials to Avoid:YES
OXIDIZING MATERIALS CAN CAUSE A VIGOROUS REACTION.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:AS W/ANY OTHER ORGANIC MATERIAL,
COMBUSTION WILL PRODUCE CARBON DIOXIDE & PROBABLY CARBON MONOXIDE.

Disposal

Waste Disposal Methods:SOAK UP LIQUIDS W/SAWDUST OR RAGS & REMOVE.
FLUSH W/WATER IF POSSIBLE. AVOID SKIN CONTACT. DISPOSAL SHOULD BE
I/A/W LOCAL, STATE & FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.